Mechanical Adjustment; Fold Angle Adjustment - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008
8.

Mechanical adjustment

8.1

Fold Angle Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the Folding Unit has been replaced.
• When a slant occurs in the crease.
1. Enter the Crease mode and make a copy. (A3 or 11x17 Size)
Exit direction
6. Make another copy and check the fold position.
A
Center
[1]
4511F3C501DA
[2]
4511F3C502DA
8. Mechanical adjustment
2. Fold the output paper along the
crease [1].
3. Fold the output paper and half and
measure the width A of the paper.
Specification: 0 ± 1.5 mm
4. If the fold position is slanted as
shown on the left, make the following
adjustment.
5. Open the Front Door, loosen the
adjustment screw [2], and move the
Folding Unit to the left to make the
adjustment.
Graduated in 1-mm divisions
• If the fold position is slanted opposite
to the figure of step 4, move the Fold-
ing Unit to the right to make the adjust-
ment.
33