Konica Minolta bizhub 362 Service Manual page 814

Field Service Ver. 1.0 Dec. 2008
Precaution for Clincher Reinstallation
• When the Clincher is installed, the position of the Stapler and the Clincher will be
misaligned. Be sure to perform the following adjustment.
[1]
[2]
[3]
[6]
[7]
4511F2C550DA
[3]
[4]
A0PGF2C511DA
[5]
4511F2C552DA
[9]
[8]
A0PGF2C512DA
1. Install the Stapler, and then install
the Staple Cartridge.
2. Use three screws [1] to temporary fix
the Clincher [2].
3. Loosen three screws [3] of the stop-
per.
4. Loosen three screws [4] of the
Clincher.
5. Aligning the protrusions of the jig [6]
with the recesses in the Stapler [5],
fit the jig to the Stapler.
NOTE
• Make sure that the protrusions of
the jig properly rest in the recesses.
6. Turn the gear [7] of the Clincher to
project the protrusions [9] of the
Clincher, and then slide to put into
the Clincher as it fits into the
recesses [8] of the jig.
4. Other
13