4. Other
[10]
4.3.7
In & Out Guide Drive Motor (M13-SK)
1. Remove the Saddle Unit.
See P.7
2. Remove the Paper Output Tray.
See P.5
3. Remove the Front Cover.
See P.5
4. Remove the Rear Cover.
See P.6
5. Remove the Upper Cover.
See P.6
[4]
[3]
[2]
[6]
[5]
14
[10]
4511F2C554DA
[3]
[1]
4511F2C513DA
[7]
[8]
4511F2C515DA
Field Service Ver. 1.0 Dec. 2008
7. Tighten six screws [10].
NOTE
• Turn the gear again and check to
see that the protrusion of the
Clincher smoothly fits into the
recess in the jig.
8. Turn the gear and remove the jig.
6. Remove the screw [1], and remove
the ground terminal [2].
7. Remove two screws [3], and remove
the holder [4].
8. Release the lock release lever [5],
and slide the Saddle Unit Mounting
Plate [6].
9. Remove the screw [7] and the
washer [8], and remove the Saddle
Unit Mounting Plate [6].