Konica Minolta bizhub 362 Service Manual page 130

Field Service Ver. 1.0 Dec. 2008
Fusing Roller Sub Thermistor side
6. Press the Thermistor Holding/Check Jig [9] up against the bracket and fix it in position.
[11]
[10]
Bracket
[9]
[9]
4040F2C733DA
[12]
4040F2C732DA
Fusing Roller Thermistor side
CAUTION
• Press the Thermistor Holding/
Check Jig squarely so as to elimi-
nate no gap between the bracket
that supports the thermistor and
the jig.
7. Remove two screws [10], the Fusing
Roller Thermistor [11], and Fusing
Roller Sub Thermistor [12].
Precautions for mounting the ther-
mistors
• When reinstalling the thermistors,
use the Thermistor Holding/Check
Jig.
• After installation, use the jig to
make sure that the bracket is not
bent.
6. Other
4040F2E753DA
91