Manual Bypass Unit Installation Check - Konica Minolta bizhub 362 Service Manual

15. Mechanical adjustment
4. After the Bypass Paper Size Unit base has been mounted, check that the lever of the
Bypass Paper Size Unit moves smoothly in a manner operatively connected to the
Bypass Guide.
5. Select [Function] from the Tech. Rep. mode and run [FD].
See P.172
15.2.2

Manual Bypass Unit Installation Check

1. Remove the Rear Right Cover.
See P.51
2. Remove the Lower Right Rear Cover.
See P.50
3. Remove the Front Manual Bypass Cover.
See P.56
4. Remove the Rear Manual Bypass Cover.
See P.56
5. Check the Tray 2 Paper Feed Guide [1] and Manual Bypass Guide [2] for correct opera-
tion.
NOTE
• Pull open the Tray 2 Paper Fed Door in the direction of the arrow and check that it
opens smoothly without binding.
• If the door binds, perform the installation procedures again for the Tray 2 Feed Roll
Assy and Manual Bypass Unit.
230
3. When the Bypass Paper Size Unit
4036fs3052c0
[1]
Field Service Ver. 1.0 Dec. 2008
base is mounted, align the lever
position of the Bypass Paper Size
Unit with the tab at the center in a
straight line.
[2]
4040F3C536DA