Konica Minolta bizhub 362 Service Manual page 443

11. Soft Switch Settings
MODE
Bit:
007
Bit
7 Select upper limit of cut-off
length after printing:
6
When a received document
5
is longer than the print paper
and if the excess length is
shorter than that specified
here, it is cut off.
If it is longer than that value
specified with these bits, it is
split into multiple pages. This
feature is enabled when the
following 2 conditions are
satisfied:
• When printing a received
document
• When bit 1 of this mode is
1 <*>
4 Select upper limit of reduc-
tion ratio of received docu-
3
ment:
2
When a received document
is longer that the print paper,
it will be reduced to fit the
paper with the upper limit
specified with these bits. This
feature is enabled when the
following 2 conditions are
satisfied:
• When printing a received
document
• When bit 1 of this mode is
0
Example: The reduction is
100 to 90% when "90%" is
specified. <*>
56
Factory setting bit
7 6 5 4 3 2 1 0
1 0 1 1 0 1 0 1
Feature
0
Bit 7-5:
Bit 4-2:
Field Service Ver. 1.0 Dec. 2008
HEX:B9 (For U.S.)
HEX:B5 (For Europe)
Logic
1
000 0 mm
001 8 mm
010 12 mm
011 14 mm
100 18 mm
101 20 mm
110 24 mm
111 Not
available
000 100 %
001 95 %
010 90 %
011 85 %
100 80 %
101 65 %
110 60 %
111 Not
available
Description
If the excess length is
longer than specified
here:
<For reduction>
• If Bit 1 is set to 0, it is
reduced when fitting
within the reduction
percent range speci-
fied with Bits 4 to 2.
<For division>
• If Bit 1 is set to 0, it is
divided when not fit-
ting within the reduc-
tion ratio range
specified with Bits 4
to 2.
• If Bit 1 is set to 1, the
excess length por-
tion is divided.
Reduction will not be
done if a received doc-
ument is still longer
than the paper for a
specified reduction.