Punch Hole Deviance Adjustment (Pu-501) - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008
8.3

Punch Hole Deviance Adjustment (PU-501)

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the Punch Kit has been replaced.
• When the Punch Kit has been removed.
[1]
1. Set the copier into the Hole Punch
mode and make a 1-sided copy from
a 1-sided original.
2. Fold the output paper in half and
check whether the punch hole posi-
tions are aligned.
Specification: 0±2 mm
3. If the punch hole position is mis-
4349F3C508DA
aligned, adjust with the following pro-
cedure.
4. Remove the Horizontal Transport
Lower Front Cover.
See P.13
[2]
5. Loosen the adjustment screw [1],
and move the Punch Unit [2] forward
or backward to make the adjustment.
6. Make another copy and check the
punch hole position.
4349F3C509DA
8. Mechanical adjustment
31