Precautions To Be Observed When Option Configuration Is Changed; Setting The Exit Tray Detection Position - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008
4.2 Precautions to be observed when option configuration is
changed
• The Exit Tray detection position must be changed depending on configuration of the
options mounted on the copier.
4.2.1

Setting the Exit Tray Detection Position

A. When only OT-602, MT-502, or SD-507 is mounted
B. When OT-602 + MT-502 or OT-602 + SD-507 are mounted
C. When only FS-530 is mounted
[1]
[2]
4349F2C541DA
[1]
[2]
4349F2C542DA
[1]
[2]
4349F2C543DA
1. Loosen the screw [1] and move it in
the direction of the arrow. Then,
tighten it at the new position.
NOTE
• This step should be done securely.
If not, any trouble may happen.
• Be sure to move the screw itself.
• Do not move the screw by using the
Adjust Plate [2].
1. Loosen the two screws [1] and move
them in the direction of the arrow.
Then, tighten them at the corre-
sponding new positions.
NOTE
• This step should be done securely.
If not, any trouble may happen.
• Be sure to move the screw itself.
• Do not move the screw by using the
Adjust Plate [2].
1. Loosen the two screws [1] and move
them in the direction of the arrow.
Then, tighten them at the corre-
sponding new positions.
NOTE
• This step should be done securely.
If not, any trouble may happen.
• Be sure to move the screw itself.
• Do not move the screw by using the
Adjust Plate [2].
4. Other
11