14. Initial Mode; 14.1 Initial Mode Function Setting Procedure; Exiting - Konica Minolta bizhub 362 Service Manual

Field service
Hide thumbs Also See for bizhub 362:
Table of Contents

Advertisement

14. Initial Mode

14. Initial Mode

14.1 Initial Mode Function Setting Procedure

1. Remove the Compact Flash Cover [1].
2. Press the Warm Restart switch [2].
3. When " " appears at the center on the left-hand side of the screen, enter "3" from the
10-Key Pad.
4. Enter the 8-digit service code and touch [END]. (Default value: 00000000)
NOTE
• When [END] is touched after a wrong service code has been entered, the Basic
screen reappears.
• At the fourth access after entries of three wrong access codes, [END] is not avail-
able on the screen. It is therefore necessary to turn OFF and ON the Main Power
Switch.
• If you forget the service code, it becomes necessary to replace the RAMS Board
with a new one. Take necessary steps not to forget the service code.
• The RAMS Board is not available as a replacement part. If it requires replacement,
contact Office Printing Support Division by way of CSES.
5. Select a function.
14.1.1

Exiting

• Touch [Exit].
224
[2]
Field Service Ver. 1.0 Dec. 2008
[1]
4040F3C533DA
4040F3C521DA

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bizhub 282Bizhub 222

Table of Contents