Konica Minolta bizhub 362 Service Manual page 485

11. Soft Switch Settings
Pattern 8 2:00 am on last Sunday, November
Pattern 9 2:00 am, April 1
Pattern 10 2:00 am, April 1
Pattern 11 <Until 2006>
2:00 am on 1st Sunday, April
<After 2007>
2:00 am on 2nd Sunday, March
Pattern 11 (Until 2006) 2:00 am on 1st Sunday, April
(From 2007) 2:00 am on 2nd Sunday, March
MODE
Bit:
198
Bit Feature
7 TX forwarding to adminis-
trator <*>
6 TX forwarding of scanner
function to administrator
<*>
5 Result report TX forward-
ing to administrator
4
NOTE
• (*1): Bit 7 of mode 198 is enabled only when "1 (forwarded)" is specified.
98
Start Time
Factory setting bit
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0
Logic
0 1
Not for- For-
warded warded
Not for- For-
warded warded
Bit 5-4: 00
01
10
11
Field Service Ver. 1.0 Dec. 2008
End Time
2:00 am on last Sunday, February
2:00 am on last Sunday, October
2:00 am, October 1
2:00 am on last Sunday, October
2:00 am on 1st Sunday, November
2:00 am on last Sunday, October
2:00 am on first Sunday, November
HEX:D0
Description
Specifies whether a received document
is forwarded to a destination specified by
the administrator.
Enabled when setting Mode 198 Bit 7 to
"1".
If you set this to "0", and perform serial
broadcast transmission including to des-
tinations other than for scanner trans-
mission, scanner transmission
documents are forwarded to the admin-
istrator.
Not output Enabled when setting
Mode 198 Bit 7 to "1".
Output for
incomplete TX
Always output
Not available