I/O Check; Check Procedure; I/O Check List; I/O Check Screen - Konica Minolta bizhub 362 Service Manual

5. I/O check

5. I/O check
5.1

Check procedure

• To allow sensors to be checked for operation easily and safely, data applied to the IC on
the board can be checked on the panel with the main body in the standby state (including
a misfeed, malfunction, and closure failure condition).
<Procedure>
1. Display the Tech. Rep. Mode screen.
See P.154 of the main body service manual.
2. Touch the [I/O Check] key.
3. Touch the [Finisher] key.
4. Touch [Fwd] three times.
5.2

I/O check list

5.2.1

I/O check screen

• This is only typical screen which may be different from what are shown on each individ-
ual main body.
8
Field Service Ver. 1.0 Dec. 2008
4510F3C506DA