Detail On Settings - Konica Minolta bizhub 362 Service Manual

10. Tech. Rep. Mode
10.10.8

Detail on settings

A. System Input
Functions • To select the system type for remote diagnosis.
Use • Use to newly build or change the system.
• Select E-Mail or Modem.
Setting/
• The default setting is "E-Mail".
Procedure
B. ID Code
Functions • To register the Service ID.
Use • Use when registering and changing Service ID.
• Enter a 7-digit code from the 10-Key Pad. (0000001 to 9999999)
Registration
Setting/
• Touch [ID Code] and enter the Service ID.
Procedure
• Touch [ID code] to register the ID.
• The [Detail Setting] will appear when the ID has been registered.
C. Detail Setting
(1) Basic
Functions • Execute the primary setting.
• Use to change the set contents.
Use
• Use to register the machine to the CS Remote Care Center.
1. Call the Tech. Rep. Mode to the screen.
2. Touch [CS Remote Care].
3. Touching the [Detail Setting] will display the primary setting.
Primary Setting
• Set the Center ID, Device ID, and the phone No.
• When e-mail is selected for system and all setup procedures are completed, E-mail
address of the Center is displayed.
* When entering the phone No, 10-Keys and keys on the screen have following meanings.
Setting/
[-] Pose
Procedure
[W] Wait
[T] Tone dial : Carry out tone dialing
[P] Pulse dial : Carry out pulse dialing
[*],[#]
Initial Transmission
• Touching the Initial Transmission key will sent the information to the CS Remote Care
Center to register the machine.
(Only when the Modem is selected on the system Input.)
200
"E-Mail" Modem
: Waits to start transmitting after dialing
: Detects the dial tone of the other end
: To be used as necessary
Field Service Ver. 1.0 Dec. 2008