D-Link xStack DGS-3120 Series Cli Reference Manual page 732

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Format
disable ospfv3
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable OSPFv3:
DGS-3120-24TC:admin#disable ospfv3
Command: disable ospfv3
Success.
DGS-3120-24TC:admin#
71-4 config ospfv3
Description
This command is used to configure an OSPFv3 interface.
Format
config ospfv3 [ipif <ipif_name 12> | all] {area <area_id> | priority <value 0-255> |
hello_interval <sec 1-65535> | dead_interval <sec 1-65535> | instance <value 0-255> | metric
<value 1-65535> | state [enable | disable] | passive [enable | disable]}(1)
Parameters
ipif - Specify to configure an OSPFv3 interface.
<ipif_name 12> - Enter the name of the OSPFv3 interface.
all - Specify to configure all OSPFv3 interfaces.
area - (Optional) Specify the OSPFv3 area ID. It is a 32-bit number in the form of an IPv4
address that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
<area_id> - Enter the OSPFv3 area ID.
priority - (Optional) Specify the priority used in the election of the Designated Router (DR).
<value 0-255> - Enter a value between 0 and 255. The default value is 1.
hello_interval - (Optional) Specify to allow the interval between the transmission of OSPFv3
Hello packets, in seconds.
<sec 1-65535> - Enter the time between 1 and 65535. The default value is 10.
dead_interval - (Optional) Specify to allow the interval between the receipt of Hello packets from
a neighbor router before the selected area declares that router down.
<sec 1-65535> - Enter the time between 1 and 65535. The default value is 40.
instance - (Optional) Specify the instance ID of the interface. Support for multiple instances on a
727