D-Link xStack DGS-3120 Series Cli Reference Manual page 435

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3120-24TC:admin#config igmp check_subscriber_source_network ipif System
enable
Command: config igmp check_subscriber_source_network ipif System enable
Success.
DGS-3120-24TC:admin#
40-5 show igmp check_subscriber_source_network
Description
This command is used to display the status of the IGMP report/leave message source IP check.
Format
show igmp check_subscriber_source_network {ipif <ipif_name 12>}
Parameters
ipif – (Optional) Specify the IP interface name to be displayed.
<ipif_name 12> - Enter the IP interface name, to be displayed, here. This name can be up to
12 characters long.
If no parameter is specified, the system will display all interfaces.
Restrictions
None.
Example
To show the status of the check subscriber for the received IGMP report/leave messages on
interface "n20":
DGS-3120-24TC:admin#show igmp check_subscriber_source_network ipif n20
Command: show igmp check_subscriber_source_network ipif n20
Interface IP Address/Netmask
------------ ------------------
n20 20.1.1.1/8
Total Entries: 1
DGS-3120-24TC:admin#
To show the status of the check subscriber for the received IGMP report/leave messages on all
interfaces:
Check Subscriber Source Network
-------------------------
Disabled
430