D-Link xStack DGS-3120 Series Cli Reference Manual page 750

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Format
disable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the password recovery mode:
DGS-3120-24TC:admin# disable password_recovery
Command: disable password_recovery
Success.
DGS-3120-24TC:admin#
72-3 show password_recovery
Description
The command is used to display the password recovery state. The displayed content includes both
the running configuration and the NV-RAM configuration.
When the password recovery state is enabled, the user can reboot the Switch and enter the
Password Recovery mode. Otherwise, the user will not be able to enter the special recovery mode.
NOTE: Only the NV-RAM configuration will take effect when the Switch restarts, the running
configuration does not take effect until being saved. That means the password recovery is
determined by the state stored in the NV-RAM and takes effect when the Switch starts up
the next time. The Running Configuration is the current configured state of the password
recovery, the configuration is deleted without being saved, or becomes the NV-RAM
configuration when being saved.
Format
show password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
745