D-Link xStack DGS-3120 Series Cli Reference Manual page 592

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
55-2 config loopback ipif
Description
This command is used to configure the loopback interface parameters.
Format
config loopback ipif <ipif_name 12> [{ipaddress <network_address> | state [enable |
disable]}(1)]
Parameters
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can be
up to 12 characters long.
ipaddress –Specify the IPv4 network address of the loopback interface.
<network_address> - Enter the IPv4 network address of the loopback interface here. It specifies
a host address and length of network mask.
state - Specify the state of the loopback interface.
enable - Specify that the loopback interface state will be enabled.
disable - Specify that the loopback interface state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the loopback interface named loopback1 with subnet address 10.0.0.1/8:
DGS-3120-24TC:admin#config loopback ipif loopback1 ipaddress 10.0.0.1/8
Command: config loopback ipif loopback1 ipaddress 10.0.0.1/8
Success.
DGS-3120-24TC:admin#
55-3 delete loopback ipif
Description
This command is used to delete a loopback interface.
Format
delete loopback ipif [<ipif_name 12> | all]
Parameters
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can be
up to 12 characters long.
all – Specify that all the IP loopback interfaces will be deleted.
587