D-Link xStack DGS-3120 Series Cli Reference Manual page 1054

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3120-24TC:admin#show traffic control 1:1-1:10
Command: show traffic control 1:1-1:10
Traffic Control Trap
Traffic Control Log
Traffic Control Auto Recover Time: 0 Minutes
Port Broadcast/ Multicast/ Unicast/
Threshold Threshold
---- --------- ---------
1:1 Enabled Disabled
1 1
1:2 Enabled Disabled
1 1
1:3 Enabled Disabled
1 1
1:4 Enabled Disabled
1 1
1:5 Enabled Disabled
1 1
1:6 Enabled Disabled
1 1
1:7 Enabled Disabled
1 1
1:8 Enabled Disabled
1 1
1:9 Enabled Disabled
1 1
1:10 Enabled Disabled
1 1
DGS-3120-24TC:admin#
112-4 config traffic control log state
Description
This command is used to configure the traffic control log state. When the log state is enabled,
traffic control states are logged when a storm occurs and when a storm is cleared. If the log state
is disabled, traffic control events are not logged.
NOTE: The log state is only applicable for shutdown mode. Since shutdown mode only support
broadcast and multicast storm control, doesn't support unicast storm control. The log only
generate for broadcast and multicast storm control.
Format
config traffic control log state [enable | disable]
Parameters
enable - Both occurred and cleared are logged.
: [Both]
: Enabled
Action
Threshold
--------- -------- -------- --------- --------
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
Disabled shutdown 5
1
1049
Count Time
down Interval
10
10
10
10
10
10
10
10
10
10
Shutdown
Forever