D-Link xStack DGS-3120 Series Cli Reference Manual page 868

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
rx_mode - Specify the RIP receive mode.
v1_only - Specify to receive RIP version 1 format packets.
v2_only - Specify to receive RIP version 2 format packets.
v1_or_v2 - Specify to receive both v1 and v2 packets.
disable - Specify that the receiving of RIP packets will be prevented.
state - Specify that the RIP state will be enabled or disabled. If the state is disabled, then RIP
packets will not be either transmitted or received by the interface. The network configured on
this interface will not be in the RIP database.
enable - Specify that the RIP state will be enabled.
disable - Specify that the RIP state will be disabled.
distribute_list_in - Specify the inbound route filter on RIP interface.
access_list - Use an IP standard access list to filter receiving RIP routes. If the access list
does not exist, user can configure successfully, but the function will not take effective until
user create the access list.
<list_name 16> - Enter the access list name.
none - Do not filter receiving RIP routes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To change the RIP receive mode for the IP interface System:
DGS-3120-24TC:admin#config rip ipif System rx_mode v1_only
Command: config rip ipif System rx_mode v1_only
Success.
DGS-3120-24TC:admin#
87-4 config rip timers
Description
This command is used to configure RIP timers.
Format
config rip timers {update <sec 5-65535> | timeout <sec 5-65535> | garbage_collection <sec
5-65535>}(1)
Parameters
update - The value of the time at which RIP updates are sent.
<sec 5-65535> - Enter the time between 5 and 65535 seconds.The default value is 30.
timeout - The value of the time after which a RIP route is declared to be invalid.
<sec 5-65535> - Enter the time between 5 and 65535 seconds.The default value is 180.
garbage_collection - The value of the time for which a RIP route will be kept before it is
removed from the routing table.
<sec 5-65535> - Enter the time between 5 and 65535 seconds.The default value is 120.
863