D-Link xStack DGS-3120 Series Cli Reference Manual page 263

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
22-19 debug dhcpv6_relay hop_count state
Description
This command is used to enable or disable debug information flag about the hop count.
Format
debug dhcpv6_relay hop_count state [enable | disable]
Parameters
enable - Specify to enable the hop count state.
disable - Specify to disable the hop count state.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable debug information flag about the hop count:
DGS-3120-24TC:admin#debug dhcpv6_relay hop_count state enable
Command: debug dhcpv6_relay hop_count state enable
Success.
DGS-3120-24TC:admin#
22-20 debug address_binding (RI and EI Mode Only)
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - To print out the debug messages when the IMPB module receives the DHCP packets.
all - Print out all debug messages.
state - This parameter configures the IMPB debug state to be enabled or disabled.
enable - Specify that the state will be enabled.
disable - Specify that the state will be disabled.
258