D-Link xStack DGS-3120 Series Cli Reference Manual page 793

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
ipif - (Optional) Specify the name of the IP interface used to display the PIM configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display all the PIM configurations of all IP interfaces.
Restrictions
None.
Example
To display PIM configurations of IP interface System:
DGS-3120-24TC:admin#show pim
Command: show pim
PIM Global State
Last Hop SPT Switchover
Register Probe Time
Register Suppression Time : 60
PIM Interface Table
Interface IP Address
------------ ------------------ --------------- -------- -------- ----- --------
System 10.90.90.90/8
Total Entries: 1
DGS-3120-24TC:admin#
80-6 config pim cbsr
Description
This command is used to configure the BSR (Bootstrap Router) candidate feature and parameters
used by this Switch. The BSR elected, will keep all the routers in the PIM-SM domain informed of
the currently assigned RP for each multicast group. As a rule, there should be multiple BSR
candidates configured in a PIM-SM domain. The reason for this is when the elected BSR becomes
unavailable, another candidate can simply take its place. In the BSR election process the BSR
candidate with the highest priority value will be determained as the elected BSR. When the highest
priority value on multiple BSR candidates are the same, the highest IP address will be selected.
Format
config pim cbsr [ipif <ipif_name 12> {priority [-1 | <value 0-255>]} | hash_masklen <value 0-
32> | bootstrap_period <value 1-255>]
: Disabled
: Never
: 5
Designated
Router
10.90.90.90
788
Hello J/P
Interval Interval Mode
30 60 DM
State
Disabled