Chapter 110 Time And Sntp Command List; Config Sntp - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 110 Time and SNTP Command
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
config sntp ipv6server {primary <ipv6addr> | secondary <ipv6addr>}(1)
show sntp
enable sntp
disable sntp
config time <date ddmthyyyy> <time hh:mm:ss>
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4,last> | e_day
<end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90
| 120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> |
offset [30 | 60 | 90 | 120]}]
show time

110-1 config sntp

Description
This command is used to change SNTP configurations.
Format
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
Parameters
primary - (Optional) SNTP primary server IP address.
<ipaddr> - Enter the IP address used for this configuration here.
secondary - (Optional) SNTP secondary server IP address.
<ipaddr> - Enter the IP address used for this configuration here.
poll-interval - (Optional) Specify the polling interval range seconds.
<int 30-99999> - Enter the polling interval range here. This value must be between 30 and
99999 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure SNTP:
List
1035