D-Link xStack DGS-3120 Series Cli Reference Manual page 735

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
stub_summary - (Optional) Specify whether the OSPFv3 stub area imports inter-area
prefix LSA advertisements.
enable - Import inter-area prefix LSA into this stub area.
disable - Stop importing inter-area prefix LSA into this stub area.
metric - (Optional) Specify the cost of default inter-area prefix LSA in OSPFv3 stub area.
<value 0-65535> - Enter the value between 0 and 65535. The default value is 1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an OSPFv3 area:
DGS-3120-24TC:admin#create ospfv3 area 1.1.1.1 type normal
Command: create ospfv3 area 1.1.1.1 type normal
Success.
DGS-3120-24TC:admin#
71-7 config ospfv3 area
Description
This command is used to configure an OSPFv3 area. The backbone area (0.0.0.0) can not be
configured to be stub area.
Format
config ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
Parameters
<area_id> - Enter the OSPFv3 area ID. It is a 32-bit number in the form of an IPv4 address that
uniquely identifies the OSPFv3 area in the OSPFv3 domain.
type - The OSPFv3 area mode of operation.
normal - Define the OSPFv3 area created as a normal area.
stub - Define the OSPFv3 area created as a stub area.
stub_summary - (Optional) Specify whether the OSPFv3 stub area imports inter-area
prefix LSA advertisements.
enable - Import inter-area prefix LSA into this stub area.
disable - Stop importing inter-area prefix LSA into this stub area.
metric - (Optional) Specify the cost of default inter-area prefix LSA in OSPFv3 stub area.
<value 0-65535> - Enter the value between 0 and 65535. The default value is 1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
730