D-Link xStack DGS-3120 Series Cli Reference Manual page 639

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
packet received by the interface has a version higher than the specified version, this packet
will be dropped.
<value 1-2> - Enter the version number value here. This value must be between 1 and 2.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD snooping querier:
DGS-3120-24TC:admin# config mld_snooping querier vlan_name default
query_interval 125 state enable
Command: config mld_snooping querier vlan_name default query_interval 125 state
enable
Success.
DGS-3120-24TC:admin#
63-3 config mld_snooping router_ports
Description
This command is used to designate a range of ports as being connected to multicast-enabled
routers. This will ensure that all packets with such a router as its destination will reach the
multicast-enabled router, regardless of protocol, etc.
Format
config mld_snooping mrouter_ports [vlan <vlan_name 32> | vlanid <vlanid_list>] [add |
delete] <portlist>
Parameters
vlan - Specify the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID list here.
add - Specify to add the router ports.
delete - Specify to delete the router ports.
<portlist> - Specify a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set up static router ports:
634