D-Link xStack DGS-3120 Series Cli Reference Manual page 271

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Format
debug ospf log state [enable | disable]
Parameters
enable - Specify that the OSPF debug log state will be enabled.
disable - Specify that the OSPF debug log state will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the OSPF debug log:
DGS-3120-24TC:admin#debug ospf log state enable
Command: debug ospf log state enable
Success.
DGS-3120-24TC:admin#
22-30 debug ospf show counter (RI Mode Only)
Description
This command is used to display OSPF statistic counters.
Format
debug ospf show counter {packet | neighbor | spf}
Parameters
packet - (Optional) Specify to display the OSPF packet counter.
neighbor - (Optional) Specify to display the OSPF neighbor event counter.
spf - (Optional) Specify to display the OSPF SPF event counter.
If the parameter is not specified, all OSPF counters will be displayed.
Restrictions
Only Administrator-level users can issue this command.
Example
To show all OSPF statistic counters:
266