D-Link xStack DGS-3120 Series Cli Reference Manual page 1070

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
priority - (Optional) Specify the priority to be used for the Virtual Router Master election process
<int 1-254> - Enter the priority value used here. This value must be between 1 and 254.
advertisement_interval - (Optional) Specify the time interval used between sending
advertisement messages.
<int 1-255> - Enter the advertisement interval value here. This value must be between 1 and
255 seconds.
preempt - (Optional) Controls whether a higher priority virtual router will preempt a lower priority
master. The preempt setting must be consistent with all the routers participating within the
same VRRP group. Default is settings is true.
true - Specify that if the backup router's priority is set higher than the masters priority, it will
become the master instead of the current one.
false - Specify that if the backup router's priority is higher than the masters priority, it will not
become the master until the master failed.
critical_ip - (Optional) Specify an IP address that will provide the most direct route to the Internet
or other critical network connections from this virtual router. This IP address must be a real IP
address of a real device on the network. If the connection from the virtual router to this IP
address fails, the virtual router will automatically be disabled. A new Master will be elected
from the backup routers participating in the VRRP group. Different critical IP addresses may
be assigned to different routers participating in the VRRP group and can therefore define
multiple routes to the Internet or other critical network connections.
<ipaddr> - Enter the critical interface's IP address used here.
critical_ip_state - (Optional) Specify the state of checking the status (active or inactive) of a
critical IP address.
enable - Specify that the critical IP state checking will be enabled.
disable - Specify that the critical IP state checking will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a VRRP entry:
DGS-3120-24TC:admin#create vrrp vrid 1 ipif System ipaddress 10.90.90.91 state
enable
Command: create vrrp vrid 1 ipif System ipaddress 10.90.90.91 state enable
Success.
DGS-3120-24TC:admin#
116-4 config vrrp vrid
Description
This command is used to configure the virtual router settings by VRID.
Format
config vrrp vrid <vrid 1-255> ipif <ipif_name 12> {state [enable | disable] | priority <int 1-
254> | ipaddress <ipaddr> | advertisement_interval <int 1-255> | preempt [true | false] |
critical_ip <ipaddr> | critical_ip_state [enable | disable]}
1065