D-Link xStack DGS-3120 Series Cli Reference Manual page 352

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
enable - Specify that the trap for the filter ICMPv6 RA all-nodes will be enabled. The trap for filter
ICMPv6 RA all-nodes will be sent out.
disable - Specify that the trap for the filter ICMPv6 RA all-nodes will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the filter ICMPv6 RA all-nodes trap state:
DGS-3120-24TC:admin#config filter icmpv6_ra_all_node trap enable
Command: config filter icmpv6_ra_all_node trap enable
Success.
DGS-3120-24TC:admin#
27-15 show filter icmpv6_ra_all_node
Description
This command is used to display the filter ICMPv6 RA all-nodes information.
Format
show filter icmpv6_ra_all_node
Parameters
None.
Restrictions
None.
Example
To display filter ICMPv6 RA all-nodes information:
DGS-3120-24TC:admin#show filter icmpv6_ra_all_node
Command: show filter icmpv6_ra_all_node
Enabled ports:1:1-1:8
Trap State: Enabled
Log State: Enabled
Permit Source Address Table:
Source IP Address
---------------------------------------
Port
---------------
347