D-Link xStack DGS-3120 Series Cli Reference Manual page 764

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Example
To configure all packets which match ACL rule profile ID=1 and access ID=1, and then route to
20.1.1.100:
DGS-3120-24TC:admin#config policy_route name danilo acl profile_id 1 access_id
1 nexthop 20.1.1.100 state enable
Command: config policy_route name danilo acl profile_id 1 access_id 1 nexthop
20.1.1.100 state enable
Success.
DGS-3120-24TC:admin#
75-4 show policy_route
Description
This command is used to display the Switch's current policy route rules.
Format
show policy_route
Parameters
None.
Restrictions
None.
Example
To display the Switch's current policy route rules:
DGS-3120-24TC:admin#show policy_route
Command: show policy_route
Policy Routing Table
---------------------
Name
-------------------------------- ----------
danilo
Total Entries: 1
DGS-3120-24TC:admin#
Profile ID Access ID Next Hop
--------- --------------- --------
1 1
759
State
20.1.1.100 Enabled