D-Link xStack DGS-3120 Series Cli Reference Manual page 1009

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3120-24TC:admin#show stack_device
Command: show stack_device
Box ID Box Type
------ ----------------
1 DGS-3120-24TC
DGS-3120-24TC:admin#
103-5 config stacking_mode
Description
This command is used to configure the state of stacking function. By default stacking mode is
enabled. Administrators need to specifically configure the stacking mode to make the Switch
stackable. Stacking mode can be changed under standalone mode only.
Format
config stacking_mode [disable | enable]
Parameters
stacking_mode - Enable or disable the Switch's stacking capability.
enable - Specify that the Switch's stacking capabilty will be enabled.
disable - Specify that the Switch's stacking capabilty will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable stacking mode:
DGS-3120-24TC:admin# config stacking_mode enable
Command: config stacking_mode enable
Change Box stacking_mode may cause devices work restart, still continue?(y/n)
y
Please wait, the switch is rebooting...
103-6 show stacking_mode
Description
This command is used to display the current stacking mode.
Format
show stacking_mode
H/W Version Serial Number
----------- --------------------
B1 PVT93CB000001
1004