Chapter 108 Telnet Client Command List - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide

Chapter 108 Telnet Client Command List

telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
108-1 telnet
Description
This command is used to start the telnet client to connect to the specific telnet server. The
parameters specified by the command will only be used for the establishment of this specific
session. They will not affect the establishment of other sessions.
Format
telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
Parameters
<ipaddr> - The IP address of the Telnet server.
<domain_name 255> - Enter the domain name of the Telnet server.
<ipv6addr> - The IPv6 address of the Telnet server.
tcp_port - (Optional) Specify the telnet server port number to be connected. If not specified, the
default port is 23.
<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and
65535.
Restrictions
None.
Example
Telnet to a Switch by specifying the IP address:
DGS-3120-24TC:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
DGS-XXXX Fast Ethernet Switch Command Line Interface
Copyright(C) 2006-2009 D-Link Corporation. All rights reserved.
UserName:
Firmware: Build 1.00.B01
1029