D-Link xStack DGS-3120 Series Cli Reference Manual page 733

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
link is accomplished through an instance ID contained in the OSPFv3 packet header. If the
instance ID configured on the interface and that of a received OSPFv3 packets do not match,
the interface discards the packet and no neighbor relationship can be established.
<value 0-255> - Enter a value between 0 and 255. The default value is 0.
metric - (Optional) Specify to allow the representative of the OSPFv3 cost to reach the specified
OSPFv3 interface.
<value 1-65535> - Enter a value between 1 and 65535. The default value is 1.
state - (Optional) Specify to enable or disable this interface to run OSPFv3.
enable - Enable the interface to run OSPFv3.
disable - Disable the interface to run OSPFv3. This is the default.
passive - (Optional) Specify that the user may select Active or Passive for this OSPFv3 interface.
Active interface actively advertises OSPFv3 to routers on other Intranets that are not part of
this specific OSPFv3 group. Passive interface does not advertise to any other routers except
those within its OSPFv3 intranet. When this field is disabled, it denotes an active interface. Its
default setting is Disabled.
enable - Specify to be passive interface.
disable - Specify to be active interface.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an OSPFv3 interface:
DGS-3120-24TC:admin#config ospfv3 ipif System area 1.1.1.1 priority 100
hello_interval 20 dead_interval 60 instance 1 metric 20 state enable passive
disable
Command: config ospfv3 ipif System area 1.1.1.1 priority 100 hello_interval 20
dead_interval 60 instance 1 metric 20 state enable passive disable
Success.
DGS-3120-24TC:admin#
71-5 show ospfv3
Description
This command is used to display OSPFv3 configurations, including global state, router ID,
OSPFv3 interfaces, areas, virtual links and area aggregations. If the parameter is set, it is used to
display the information of one or all OSPFv3 interfaces.
Format
show ospfv3 {[ipif <ipif_name 12> | all]}
Parameters
ipif - (Optional) Specify the OSPFv3 interface.
<ipif_name 12> - Enter the OSPFv3 interface name.
all - (Optional) Specify to display all OSPFv3 interfaces.
728