D-Link xStack DGS-3120 Series Cli Reference Manual page 537

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
49-21 create jwac user
Description
This command is used to create JWAC users in the local database. When "local" is chosen while
configuring the JWAC RADIUS protocol, the local database will be used.
Format
create jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Specify the user name to be created.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a JWAC user in the local database:
DGS-3120-24TC:admin#create jwac user 112233
Command: create jwac user 112233
Enter a case-sensitive new password:*****
Enter the new password again for confirmation:*****
Success.
DGS-3120-24TC:admin#
49-22 config jwac user
Description
This command is used to configure a JWAC user.
Format
config jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Specify the user name to be configured.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
532