D-Link xStack DGS-3120 Series Cli Reference Manual page 637

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Format
config mld_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all] {state [enable |
disable] | topology_changes_notification [ignore | process] | fast_done [enable | disable] |
proxy_reporting {state [enable | disable] | source_ip <ipv6addr>}(1)}(1)
Parameters
vlan_name - Specify the name of the VLAN for which MLD snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN for which MLD snooping is to be configured.
<vlanid_list> - Enter the VLAN ID list here.
all - Specify all VLANs for which MLD snooping is to be configured.
state - Enable or disable MLD snooping for the chosen VLAN.
enable - Enter enable here to enable MLD snooping for the chosen VLAN.
disable - Enter disable here to disable MLD snooping for the chosen VLAN.
topology_changes_notification - (Optional) Specify that MLD snooping should be aware of link-
layer topology changes caused by Spanning Tree operation or not.
ignore - Specify that MLD snooping will ignore link-layer topology changes caused by
Spanning Tree operation. General queries won't be sent on the same domain of link-layer
topology changes.
process - Specify that MLD snooping will process link-layer topology changes caused by
Spanning Tree operation. General queries will be sent on the same domain of link-layer
topology changes.
fast_done - Enable or disable MLD snooping fast_leave function.
enable - Enter enable here to enable MLD snooping fast_leave function. If enable, the
membership is immediately removed when the system receive the MLD leave message.
disable - Enter disable here to disable MLD snooping fast_leave function.
proxy reporting - Specify MLD proxy reporting.
state - Enable or disable the proxy reporting.
enable - Enable the proxy reporting.
disable - Disable the proxy reporting.
source_ip - Specify the source IP of proxy reporting integrated report. Default value is zero
IP.
<ipv6addr> - Enter the Ipv6 address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure MLD snooping:
DGS-3120-24TC:admin#config mld_snooping vlan_name default state enable
Command: config mld_snooping vlan_name default state enable
Success.
DGS-3120-24TC:admin#
632