D-Link xStack DGS-3120 Series Cli Reference Manual page 747

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3120-24TC:admin#create ipv6route redistribute dst ospfv3 src static
Command: create ipv6route redistribute dst ospfv3 src static
Success.
DGS-3120-24TC:admin#
71-22 config ipv6route redistribute dst ospfv3 src
Description
This command is used to configure the settings of the IPv6 route redistribution to import route of
other protocol into OSPFv3.
Format
config ipv6route redistribute dst ospfv3 src [local | static | ripng] {mettype [1 | 2] | metric
<value 1-16777214>}(1)
Parameters
local - Redistribute local routes into OSPFv3.
static - Redistribute static routes into OSPFv3.
ripng - Redistribute RIPng routes into OSPFv3.
mettype - (Optional) Allow the selection of one of two methods for calculating the metric value.
1 - 1 calculates the metric (for other routing protocols to OSPFv3) by adding the destination's
interface cost to the metric entered in the Metric field.
2 - 2 uses the metric entered in the Metric field without change. If the metric type is not
specified, it will be type 2.
metric - (Optional) Specify the metric for the redistributed routes.
<value 1-16777214> - Enter the value between 1 and 16777214. The default value is 20.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the metric of OSPFv3 route redistribution:
DGS-3120-24TC:admin#config ipv6route redistribute dst ospfv3 src static mettype
1 metric 100
Command: config ipv6route redistribute dst ospfv3 src static mettype 1 metric
100
Success.
DGS-3120-24TC:admin#
742