D-Link xStack DGS-3120 Series Cli Reference Manual page 810

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3120-24TC:admin#show pim6 ipif System
Command: show pim6 ipif System
Interface name
Interface Link-Local Address
Interface Global Address
PIM6 Mode
State
Designated Router
Designated Router Priority
Designated Router Priority Enabled : True
Hello Interval
Triggered Hello Interval
Hello Holdtime
Join Prune Interval
Join Prune Holdtime
LAN Delay Enabled
Propagation Delay
Override Interval
Effective Propagation Delay
Effective Override Interval
Join Suppression Enabled
Bidirectional Capable
BSR Domain Border
Stub interface
DGS-3120-24TC:admin#
81-3 config pim6 cbsr
Description
This command is used to set the C-BSR state, the priority and the hash mask length of the
candidate bootstrap router on an interface.
Format
config pim6 cbsr {ipif <ipif_name 12> state [enable | disable] | priority <value 0-255> |
hash_masklen <value 0-128>}(1)
Parameters
ipif - Specify the IP interface.
<ipif_name 12> - Enter the IP interface name. This name can be up to 12 characters long.
state - Specify to determine whether the input interface can be a C-BSR.
enable - Specify that the interface is a C-BSR.
disable - Specify that the interface is not a C-BSR. This is the default.
priority - (Optional) Specify to set the C-BSR priority.
<value 0-255> - Enter the value between 0 and 255. The default value is 64.
hash_masklen - Specify the length in bits of the mask. This makes use of a hash function for the
case where a group range has multiple RPs with the same priority.
<value 0-128> - Enter the value must be between 0 and 128. The default value is 126
: System
: -
: -
: SM
: Enabled
: -
: 1
: 60 sec
: 5 sec
: 210 sec
: 60 sec
: 210 sec
: True
: 1 sec
: 3 sec
: 1 sec
: 3 sec
: False
: False
: Disabled
: Disabled
805