Chapter 107 System Severity Command List - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 107 System Severity Command
config system_severity [trap | log | all] [emergency | alert| critical | error | warning | notice |
information | debug | <level 0-7>]
show system_severity
107-1 config system_severity
Description
This command is used to configure the severity level control for the system.
When the user chooses a specific level to log or trap, messages at that severity level or more will
be logged or trapped to SNMP managers.
Format
config system_severity [trap | log | all] [emergency | alert| critical | error | warning | notice |
information | debug | <level 0-7>]
Parameters
trap - Specify the severity level control for traps.
log - Specify the severity level control for the log.
all - Specify the severity level control for traps and the log.
emergency - Severity level 0.
alert - Severity level 1.
critical - Severity level 2.
error - Severity level 3.
warning - Severity level 4.
notice - Severity level 5.
information - Severity level 6.
debug - Severity level 7.
<level 0-7> - Enter the severity level here. This value must be between 0 and 7.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure severity level control as information level for trap:
DGS-3120-24TC:admin#config system_severity trap warning
Command: config system_severity trap warning
Success.
DGS-3120-24TC:admin#
List
1027