®
xStack
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Example
To set the maximum number of groups that can be learned by data driven:
DGS-3120-24TC:admin# config mld_snooping data_driven_learning max_learned_entry
50
Command: config mld_snooping data_driven_learning max_learned_entry 50
Success.
DGS-3120-24TC:admin#
63-17 clear mld_snooping data_driven_group (EI and SI Mode Only)
Description
This command is used to delete the MLD snooping groups learned by data driven.
Format
clear mld_snooping data_driven_group [all | [vlan_name <vlan_name 32> | vlanid
<vlanid_list>] [<ipv6addr>| all]]
Parameters
all - Specify all VLANs to which IGMP snooping groups will be deleted.
vlan_name - Specify the VLAN name.
<vlan_name 32> - Enter the VLAN name here.
vlanid - Specify the VLAN ID.
<vlanid_list> - Enter the VLAN ID list here.
<ipaddr> - Specify the group's IP address learned by data driven.
all - Specify to clear all data driven groups of the specified VLAN.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete all the groups learned by data-driven:
DGS-3120-24TC:admin# clear mld_snooping data_driven_group all
Command: clear mld_snooping data_driven_group all
Success.
DGS-3120-24TC:admin#
63-18 show mld_snooping statistic counter
Description
This command is used to display the statistics counter for MLD protocol packets that are received
by the Switch since MLD snooping was enabled.
647