D-Link xStack DGS-3120 Series Cli Reference Manual page 350

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
<ipv6addr> - Enter the source address of entry which will be created into the Filter ICMPv6 RA
All-nodes forward list here.
state - Specify whether the port's filter DHCPv6 server function is enabled or disabled.
enable - Specify that the filter option is enabled.
disable - Specify that the filter option is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a filter ICMPv6 RA All-nodes permit entry on port 1:5:
DGS-3120-24TC:admin#create filter icmpv6_ra_all_node permit sip 2200::5 ports
1:5
Command: create filter icmpv6_ra_all_node permit sip 2200::5 ports 1:5
Success.
DGS-3120-24TC:admin#
27-12 config filter icmpv6_ra_all_node log
Description
This command is used to enable or disable the filter ICMPv6 RA All-nodes log state.
Format
config filter icmpv6_ra_all_node log [enable | disable]
Parameters
enable - Specify that the log for the filter ICMPv6 RA will be enabled. The log for filter ICMPv6
RA all-nodes will be generated.
disable - Specify that the log for the filter ICMPv6 RA will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the filter ICMPv6 RA all-nodes log state:
DGS-3120-24TC:admin#config filter icmpv6_ra_all_node log enable
Command: config filter icmpv6_ra_all_node log enable
Success.
DGS-3120-24TC:admin#
345