D-Link xStack DGS-3420 Series Reference Manual page 96

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator level can issue this command.
Example
To configure the RADIUS server host:
DGS-3420-28SC:admin#config radius server_host 10.1.1.222 key "abc123"
Command: config radius server_host 10.1.1.222 key "abc123"
Success.
DGS-3420-28SC:admin#
4-40 config radius source_ipif
Description
This command is used to specify source interface for all outgoing RADIUS packets.
Format
config radius source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name used here.
<ipaddr> - Enter the IPv4 address used here.
<ipv6addr> - Enter the IPv6 address used here.
none - Specifies to revert to the default route table for all outgoing RADIUS packet.
Restrictions
Only Administrator level can issue this command.
Example
To specify an interface as the source interface for all outgoing RADIUS packets.
DGS-3420-28SC:admin#config radius source_ipif if_v200
Command: config radius source_ipif if_v200
Success.
DGS-3420-28SC:admin#
91