D-Link xStack DGS-3420 Series Reference Manual page 47

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
enable - The authorization attributes such as VLAN, 802.1p default priority, and ACL assigned by the
RADUIS server will be accepted if the global authorization status is enabled. The default state is
enabled.
disable - The authorization attributes assigned by the RADUIS server will not be accepted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the 802.1X state of acceptation of an authorized configuration:
DGS-3420-28SC:admin#config 802.1x authorization attributes radius enable
Command: config 802.1x authorization attributes radius enable
Success.
DGS-3420-28SC:admin#
3-13 config 802.1x init
Description
This command is used to initialize the authentication state machine of some or all.
Format
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
Parameters
port_based ports - Used to configure authentication in port-based mode.
<portlist> - Specify a range of ports to be configured.
all - Specify to configure all ports.
mac_based ports - To configure authentication in host-based 802.1X mode.
<portlist> - Specify a range of ports to be configured.
all - Specify to configure all ports.
mac_address - (Optional) Specify the MAC address of the host.
<macaddr> - Enter the MAC address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
42