D-Link xStack DGS-3420 Series Reference Manual page 45

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the 802.1X PDU forwarding state:
DGS-3420-28SC:admin#config 802.1x fwd_pdu system enable
Command: config 802.1x fwd_pdu system enable
Success.
DGS-3420-28SC:admin#
3-11 config 802.1x auth_parameter ports
Description
This command is used to configure the parameters that control the operation of the authenticator
associated with a port.
Format
config 802.1x auth_parameter ports [<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-65535> |
supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> | max_req <value 1-10> |
reauth_period <sec 1-65535> | max_users [<value 1-448> | no_limit] | enable_reauth [enable |
disable]}(1)]
Parameters
<portlist> - Specify a range of ports to be configured.
all - Specify to configure all ports.
default - Set all parameters to the default value.
direction - (Optional) Set the direction of access control.
both - For bidirectional access control.
in - For ingress access control.
port_control - (Optional) Force a specific port to be unconditionally authorized or unauthorized by
setting the parameter of port_control to be force_authorized or force_unauthorized. Besides, the
controlled port will reflect the outcome of authentication if port_control is auto.
force_authorized - The port transmits and receives normal traffic without 802.1X-based
authentication of the client.
auto - The port begins in the unauthorized state, and relays authentication messages between the
client and the authentication server.
force_unauthorized - The port will remain in the unauthorized state, ignoring all attempts by the
client to authenticate.
quiet_period - (Optional) The initialization value of the quietWhile timer. The default value is 60 s
and can be any value from 0 to 65535.
<sec 0-65535> - The quiet period value must be between 0 an 65535 seconds.
tx_period - (Optional) The initialization value of the txWhen timer. The default value is 30 s and can
40