Warning Message - Epson ColorPage EPL-C8200 Service Manual
Color laser printer
Hide thumbs
Also See for ColorPage EPL-C8200:
- Setup manual (90 pages) ,
- Unpacking manual (24 pages) ,
- Quick reference (21 pages)
Table of Contents
Advertisement
EPSON ColorPage EPL-C8200
5.1.2.3 Warning Message
Warning errors have no effect on printer operation.
Menus Locked
LED:
No effect on LED state.
Explanation:
Panel setting change was attempted despite "Panel
Lock" is effective in EJL.
Solution:
Press the Continue button.
PS3 Hard Disk full
LED:
No effect on LED state.
Explanation:
When a HDD unit is used for PS3, the area for PS3
has reached the limit.
Solution:
Press the Continue button or reset the printer.
Collate was disabled
LED:
No effect on LED state.
Explanation:
There is not enough memory to save a whole 1-job
data when copy is designated. The warning message
appears during the 1st copy.
Solution:
Press the Continue button. Adding optional memory
is recommended.
Check Paper Size
LED:
No effect on LED state.
Condition:
"Size Ignore" in the "Config" menu = Off
Explanation:
The selected paper size (PAGE SIZE) and the size of
the paper fed do not match. If this error does not
occur when the paper is fed from the paper tray, the
value for MP tray size in the printing menu is
Chapter 5
Troubleshooting
replaced with the value for the Page Size.
Depending on the paper sizes, the printer may not be
able to detect paper size mismatches.
NOTE: When this warning occurs, be sure to check if any pages (of
the wrong size) were printed before the printer detected the
paper size mismatch.
Solution:
Perform either of the following to clear the warning.
1. Press the Continue button to clear the error.
2. Perform a Reset operation or warm boot.
Time Exceeded
LED:
No effect on LED state.
Explanation:
Paper was forcibly output blank as the print data did
not arrive within the specified time (set on the engine
side) even though the paper was pre-fed.
Solution:
The printer attempts printing again using the same
data. If the same problem occurs, the printer ejects
the pre-fed paper and continues to print with the next
data. Perform any of the following to clear the
message.
1. Press the Continue button.
2. Perform a Reset operation.
Revision A
5-11
Advertisement
Chapters
Table of Contents
Troubleshooting
