2Nd Btr Cam Assembly Removal (Pl8.1.10) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.11.6 2ND BTR CAM ASSEMBLY Removal (PL8.1.10)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
6. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
7. Pull out the MAIN P/H ASSEMBLY with the MSI ASSEMBLY on it.
(See Section 3.2.8.1.)
8. Remove the ROS ASSEMBLY. (See Section 3.2.9.3.)
9. Remove the ADC SENSOR ASSEMBLY. (See Section 3.2.9.4.)
10. Remove the XL RAIL ASSEMBLY. (See Section 3.2.9.5.)
11. Remove the FUSER ASSEMBLY with the EXIT TRAY ASSEMBLY
and the OIL ROLL ASSEMBLY. (See Section 3.2.12.2.)
12. Remove the HVPS. (See Section 3.2.16.2.)
13. Remove the TRANSFER ASSEMBLY. (See Section 3.2.11.2.)
14. Remove the BTR CAM SOLENOID. (See Section 3.2.11.3.)
15. Remove the BELT CLEANER ASSEMBLY. (See Section 3.2.11.4.)
16. Remove the 2ND BTR ASSEMBLY. (See Section 3.2.11.5.)
17. Release the DTS WIRE from all clamps and bring it to the inner side
of the frame.
Chapter 3 Disassembly and Assembly/Adjustment
18. Remove 3 screws (gold, cup head, 4mm) securing the 2ND BTR
CAM ASSEMBLY.
NOTE: In the following step, be careful not to drop and lose the BTR
BEARING-4 and the BTR BEARING-6 as they will come off.
19. Shift the 2ND BTR CAM ASSEMBLY to the front and remove the
TORQUE GEAR SHAFT and the BTR CAM ASSEMBLY from the
BTR BEARING-4 and the BTR BEARING-6, respectively.
NOTE: In the following step, be careful not to catch the wire in the
frame.
20. Lift the 2ND BTR CAM ASSEMBLY up to remove.
Figure 3-85. 2ND BTR CAM ASSEMBLY Removal
Route the wire tightly via the clamps.
Revision A
3-71