Feed Roll Assembly Removal (Pl3.1.1) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.6.5 FEED ROLL ASSEMBLY Removal (PL3.1.1)

1. Remove the REAR COVER ASSEMBLY.
2. Remove the UNIVERSAL TRAY. (See Section 3.2.5.1.)
3. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
4. Remove the MAIN P/H ASSEMBLY with the MSI TRAY ASSEMBLY
installed on it. (See Section 3.2.8.1.)
5. Remove the FEED SOLENOID. (See Section 3.2.6.4.)
6. Remove the FEED SPRING from the FEED GEAR and the frame.
7. Remove the E-ring securing the FEED GEAR and remove the
FEED GEAR.
8. Remove the screw (silver, 8mm) securing the FEED SHAFT GUIDE
and remove the FEED SHAFT GUIDE and FEED BEARING on the
front.
9. Shift the FEED ROLL ASSEMBLY forward to release the rear end
from the frame. Then move the end downward and move the FEED
ROLL ASSEMBLY backward, avoiding contact with the TRAY N/P
SENSOR ASSEMBLY, and remove it along with the FEED
BEARING.
10. Remove the E-ring and the FEED BEARING from the REED ROLL
ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-22. FEED ROLL ASSEMBLY Removal
After installing the FEED ROLL ASSEMBLY, check that
the notch of the FEED GEAR is held at the arm of the
FEED SOLENOID.
Revision A
3-22