Cleaner Cam Solenoid Removal (Pl9.4.23) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.12.17 CLEANER CAM SOLENOID Removal (PL9.4.23)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
NOTE: In the following step, the FUSER REAR RAIL and the
FUSER TRAY ASSEMBLY will be kept connected with the
harness. Therefore, do not leave the FUSER TRAY
ASSEMBLY too far from the fuser rear rail.
5. Remove 2 screws (gold, tapped, 10mm) securing the FUSER REAR
RAIL, and separate the FUSER REAR RAIL from the FUSER TRAY
ASSEMBLY.
6. Disconnect the connector (P/J62) for the CLEANER CAM
SOLENOID and release the harness from the frame.
7. Remove 2 screws (gold, tapped, 10mm) securing the INPUT
BRACKET FT and remove the INPUT BRACKET FT along with the
FUSER EARTH-A.
8. Remove 2 screws (gold, tapped, 10mm) securing the CLEANER
CAM SOLENOID and remove the CLEANER CAM SOLENOID.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-109. CLEANER CAM SOLENOID Removal
Follow the steps below when installing the
CLEANER CAM SOLENOID:
1. The arm on the CLEANER CAM ASSEMBLY is in
the induced position.
2. Set the lower side of the tip of the arm staying in
contact with the Spring Clutch of the CLEANER
CAM ASSEMBLY, and fix the solenoid.
Figure 3-110. CLEANER CAM SOLENOID Installation
Revision A
3-91