Rear Ohp Sensor Removal (Pl5.2.32) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.8.13 REAR OHP SENSOR Removal (PL5.2.32)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
NOTE: In the following steps, hold the REGI. CHUTE ASSEMBLY to
keep it closed while turning over the MAIN P/H ASSEMBLY.
NOTE: In the following step, do not move the OHP SENSOR
ASSEMBLY too away from the P/H FRAME ASSEMBLY,
since they are connected with the harness.
4. Remove the screw (gold, tapped, 8mm) securing the OHP SENSOR
ASSEMBLY, and remove the OHP SENSOR ASSEMBLY from the
P/H FRAME ASSEMBLY.
5. Disconnect the connectors P/J99 for the REAR OHP SENSOR.
6. Remove the screw (gold, 6mm) securing the REAR OHP SENSOR
and remove the REAR OHP SENSOR.
When installing the OHP SENSOR ASSEMBLY, make
sure the harnesses are not caught between the OHP
SENSOR ASSEMBLY and P/H FRAME ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-57. REAR OHP SENSOR Removal
Revision A
3-50