Pre-Regi. Clutch Removal (Pl5.2.8) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.8.5 PRE-REGI. CLUTCH Removal (PL5.2.8)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
NOTE: In the following step, hold the REGI. CHUTE ASSEMBLY to
keep it closed while turning over the MAIN P/H ASSEMBLY.
4. Remove 2 screws (gold, tapped, 8mm) securing the PRE-REGI.
GEAR ASSEMBLY and remove it.
Figure 3-47. PRE-REGI. CLUTCH Removal (1/2)
5. Disconnect the connector (P/J95) for the PRE-REGI. CLUTCH from
the back of the MAIN P/H ASSEMBLY, and release the harness.
NOTE: In the following step, be careful not to drop gears as they will
be disengaged.
Chapter 3 Disassembly and Assembly/Adjustment
6. Remove 2 E-rings fixing the PRE-REGI. SUPPORT and remove the
PRE-REGI. SUPPORT toward the rear.
7. Among 2 PRE-REGI. GEAR 1, remove the outer one to the rear
from the stud.
8. Disconnect the connector (P/J95) for the PRE-REGI. CLUTCH
through the hole to the back of the MAIN P/H ASSEMBLY.
9. Remove the PRE-REGI. CLUTCH from the stud and remove the
PRE-REGI CLUTCH.
Figure 3-48. PRE-REGI. CLUTCH Removal (2/2)


When installing the PRE-REGI. CLUTCH, make sure
the notch on the clutch is properly aligned with the pin
on the MSI FRAME ASSEMBLY.


Route the harness carefully so it does not touch any
gear.


If it is hard to connect the PRE-REGI CLUTCH
connector, release the harness from the clump, then
connect the connector.
Revision A
3-42