Fip-1.54 "Paper Out Lc1 - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

FIP-1.54 "PAPER OUT LC1"

Step Check point
Perform the preliminary inspection.
Parts to inspect:
1
UNIVERSAL CASSETTE, BOTTOM PLATE ASSY, LOW
PAPER SENSOR, FEEDER PWB, MCU PWB
Isolation: Engine or Controller?
Run the Engine test print or diagnostic test print.
2
(10 sheets for each of single and continuous print)

Are the outputs normal?
Check: UNIVERSAL CASSETTE
3
Is the UNIVERSAL CASSETTE smoothly inserted?
Check: BOTTOM PLATE ASSY
Remove the TURN IN CHUTE-3T and then insert the
4
UNIVERSAL CASSETTE.

Does the BOTTOM PLATE ASSY properly lift up when
the UNIVERSAL CASSETTE is inserted?
Check: LOW PAPER SENSOR installation

5
Is the LOW PAPER SENSOR properly installed?
Check: LOW PAPER SENSOR

Is the LOW PAPER SENSOR properly functioning?
6
Diag Tool: Digital Input Test
Device code: 13
Check: FEEDER PWB
7
Replace the FEEDER PWB.

Does the problem still occur?
Chapter 5 Troubleshooting
Remedy
Yes
Replace/reinstall the defective part(s).
Check the Controller PWB.
If the problem still occurs, go to step 3.
Go to Step 4.
Go to Step 5.
With the diagnostic tool, go to step 6.
Without the diagnostic tool, go to FIP-
2.4 "LOW PAPER SENSOR is
Defective".
Go to Step 7.
Replace the MCU PWB.
No
Go to Step 2.
Go to Step 3.
Replace the defective part.
Replace the defective part.
Install the LOW PAPER SENSOR
properly.
Go to FIP-2.4 "LOW PAPER SENSOR
is Defective".
Problem solved.
Revision A
5-66