Cartridge Sensor Removal (Pl7.2.26) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.10.6 CARTRIDGE SENSOR Removal (PL7.2.26)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the FUSER ASSEMBLY with the EXIT TRAY ASSEMBLY
and OIL ROLL ASSEMBLY installed. (See Section 3.2.12.1.)
4. Remove the EXIT UPPER ASSEMBLY. (See Section 3.2.13.2.)
5. Remove the EXIT LOWER ASSEMBLY. (See Section 3.2.13.3.)
6. Release the harness from the clamp holding the CART. SENSOR
HARNESS to the DEVE. TIE PLATE.
7. Using a mini driver, push inside of 2 concaves in the CART.
SENSOR ASSEMBLY to release hooks from the frame. Then shift
the CART. SENSOR ASSEMBLY to the left and remove it.
8. Disconnect the connector (P/J168) for the CARTRIDGE SENSOR
and remove the CART. SENSOR HARNESS.
Figure 3-73. CARTRIDGE SENSOR Remove (1/2)
Chapter 3 Disassembly and Assembly/Adjustment
9. Remove the screw (gold, tapped, 10mm) securing the CARTRIDGE
SENSOR, and remove the CARTRIDGE SENSOR from the CART.
SENSOR HOLDER.
Figure 3-74. CARTRIDGE SENSOR Removal (2/2)


Route the harness carefully so it will not be caught.


Make sure the harness is not slack in the CART.
SENSOR HOLDER.
Revision A
3-63