Msi Clutch Removal (Pl4.2.26) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.7.11 MSI CLUTCH Removal (PL4.2.26)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MSI FRONT COVER. (See Section 3.2.7.3.)
4. Remove the MSI REAR COVER. (See Section 3.2.7.4.)
5. Remove the MSI TOP COVER ASSEMBLY. (See Section 3.2.7.5.)
6. Disconnect the connector (P/J202B) for the MSI CLUTCH and
release the harness from the clamp.
7. Remove 3 screws (gold, tapped, 12mm) securing the MSI HOLDER,
and remove the MSI HOLDER.
NOTE: In the following step, be careful not to drop and lose the
PICK UP SPRING.
8. Remove the PICK UP SPRING from the CLUTCH BRACKET and
PICK UP GEAR.
NOTE: In the following step, be careful not to drop the MSI FRONT
BEARING as it will come off.
9. Remove 3 screws (gold, tapped, 8mm) securing the CLUTCH
BRACKET and remove it along with the MSI CLUTCH.
NOTE: In the following step, be careful not to drop the MSI REAR
BEARING as it will come off.
10. Remove the MSI CLUTCH, MSI GEAR, and the MSI SHAFT from
the CLUTCH BRACKET.
11. Remove the MSI GEAR from the MSI SHAFT.
Chapter 3 Disassembly and Assembly/Adjustment
12. Remove the E-ring securing the MSI SHAFT and remove the shaft
from the MSI CLUTCH.
Figure 3-37. MSI CLUTCH Removal


When routing the harness, make sure it is not
touching any gear.


When installing the MSI CLUTCH, fit the pin on the
CLUTCH BRACKET with the notch on the MSI
CLUTCH.
Revision A
3-34