Epson ColorPage EPL-C8200 Service Manual page 57

EPSON ColorPage EPL-C8200
Paper Type
Plain
Letterhead
Bond
Recycled
Color
Trnsprincy
Labels
Note there is a possibility that the paper types which
determine the printing speed and CM differ. In this case,
"Check Paper Type" is indicated.
Thick (Envelopes, Thick paper)


Printing Speed: Half speed mode


CM:
Trnsprnc (OHP sheet)


Printing Speed: Half speed mode


CM: OHP
Setup Menu
1. Standby
Turns on/off the standby mode for saving energy while the printer is
idle.
Enable: The standby mode is enabled.
Disable: The standby mode is disabled.
When the standby mode is on, the printer enters the standby mode
1 or 2 according to the printer conditions listed below.
1) After emulation changeover, at least one printable images is
completed.
2) Print request
Chapter 1 Product Descriptions
CM
Normal paper
Normal paper
Normal paper
Normal paper
Normal paper
OHP
Normal paper
Normal paper
3) Reset through the control panel
4) Warm-boot
5) "Standby" is set to "Disable".
After any of the conditions above occurs, if a half of the specified
time-out interval has passed without any occurrence of the
conditions above, the printer enters the standby mode 1. While in
this status, if any of the conditions above still does not occur within
another half of the specified time-out interval, the standby mode 2
takes over. When any of the conditions above occurs, the energy
save function is temporarily disabled (the printer returns to the
normal standby mode or printing mode) to clear the total standby
mode time to zero.
Standby mode 1
The printer uses less power than in the normal standby mode by
controlling the fuser temperature within the specified range. This
mode does not meet the energy-star requirement. Warm-up time
(60 minutes to recover to the normal standby mode) is shorter than
in standby mode 2.
Standby mode 2
The standby mode 2 keeps the Fuser Unit and the mechanism
circuits turned off constantly and maximally, respectively, to manage
further energy save than the standby mode 1. This mode, complying
with the energy star program (45 W or less), can minimize power
consumption but requires approximately 300 seconds for warm-up
time (standby mode 2 normal standby mode), which is longer than
standby mode 1.
2. C/M/Y/K Toner
Shows the remaining level of each toner in five steps.
Values are to be read only.
F 100% Toner level > 75%
E
F 75% Toner level > 50%
E
E F
50% Toner level > 25%
E F
25% Toner level > 0%
E F
Toner level = 0%
Revision A
1-42